Skip to content

{ Category Archives } monome

Aluminum Faceplate For SparkFun Button Arduinome Arrives!

Just received some aluminum faceplates for my arduinome that I got through a group buy organized by @z15 on the monome community forum. (Thanks!)
These aluminum panels are each 5 mm thick which leaves about 2 mm of the SparkFun buttons exposed. My initial test of the faceplate has resulted in a lot of the buttons [...]

2010 01 09 arduino
instrument
make Comments (0)

Look Ma, No Loops! A Monome In The Hands Of A Master

I just had to share this brilliant little monome performance piece by edison. It really makes me want to finish my monome clone which is complete but for a case. Sure wish machinecollective were still making their beautiful cases.

edison – tonka truck from edison on Vimeo.
edison describes this piece on his Vimeo page as:
“all one [...]

2009 11 28 sound Comments (0)